Using Cleaning Chemicals in Mold Removal

March 12, 2020 10:13 pm Published by Leave your thoughts

If your home has recently been affected by storm damage, sewer backup or other causes that resulted in water damage, it’s important to take quick action so you can prevent the growth and spread of mold and mildew. You’d be amazed at how quickly mold will set in, especially when there is a combination of warmth and moisture present, so your ability to act quickly can prevent you from dealing with some seriously expensive remediation efforts.

Here’s a quick overview of the cleanup actions you’ll need to take after a flood, and when you’ll need to use mold removal chemicals like bleach in Portland, OR.

Small amounts of mold and water damage

If your home only sustained a little bit of water damage and you’ve only found a small amount of mold, bleach might not be necessary. You should make sure to remove all moldy and water-damaged items from your home, but if the problem is not severe, you might be able to get away with just cleaning all hard surfaces with a water and dish soap mixture and then drying those surfaces thoroughly. You should run a fan or dehumidifier in the affected area to help with ventilation and drying.

Moderate mold damage

If you sustained moderate mold damage, removing the items from your home and wiping down surfaces with dish soap probably won’t be sufficient in resolving the problem. You’ll need to get a little more in-depth with your cleaning, scrubbing down all cleanable surfaces in your home’s affected areas with a bristle brush and soapy water. For any mold on surfaces, use a bleach solution of eight ounces per gallon of water. As always, make sure you dry everything thoroughly.

Severe mold damage

If the inside of your home has a significant amount of debris, and you notice thick mud or dirt on the floor and walls, it is crucial to get rid of that debris and then take all the steps necessary to remove and prevent mold. You will not be able to effectively remove the mold in your home if you can’t first get rid of the dirt and mud.

So, with this in mind, remove all moldy and water-damaged items from your home, then begin digging out any mud and dirt. (This tends to be a problem after major storms that caused serious damage to your home.) Then, use a wet vacuum to remove any remaining dirt or standing water before starting the scrubbing process. All cleanable, hard surfaces should be cleaned with soapy water before you begin to disinfect with bleach. Household laundry bleach is just fine—apply it to surfaces as described above.

Then, to finish, you should once again make sure you dry all surfaces thoroughly, using a fan, air conditioner or dehumidifier. Just make sure any fan or dehumidifier you use wasn’t also affected by the storm, or it could blow mold spores around your house.

For information about the <a href=”/” title=”active mold control”>mold removal chemicals</a> in Portland, OR that the professionals will use when treating your home, contact Active Mold Control LLC today.

Categorised in:

This post was written by admin

Leave a Reply

Your email address will not be published. Required fields are marked *